Service Procedure

Please verify that no Malfunction Indicator Lights (MIL) are illuminated on the vehicle instrument cluster during normal operation. If there are, make any necessary repair before proceeding with reprogramming.

TCM Reprogramming Precautions

Before reprogramming the TCM, the following precautions must be observed:

1) Only use the appropriate reprogramming cables P/N 22775Z0C00 or 22775AA060 for TCM reprogramming.

2) Keep the vehicle at least 150 feet (50 meters) from high voltage power lines.

3) Keep the vehicle at least 30 feet (10 meters) from any machinery that creates high voltage.

4) Keep the vehicle at least 6 feet (2 meters) away from other vehicles that may generate electrical "noise". (Example: Other vehicle being checked for ignition spark, etc.)

5) Keep the vehicle at least 6 feet (2 meters) away from any electrical device that can generate an electronic wave, such as mobile phones, pagers, radios, etc.

6) Turn off electronic devices that can generate electromagnetic waves (mobile phones, pagers, etc. - no radios).

7) Turn off the vehicle's electrical devices before reprogramming (every light, seat heater, audio system. Do not use the cigarette lighter, power seat switch, etc. during reprogramming)

8) Do not attempt TCM reprogramming if the vehicle's under hood temperature is below 32°F (0° Celsius).

9) Ensure the vehicle's battery is fully charged.

TCM Reprogramming Instructions

Using the Select Monitor Reprogramming Cable, Part Number 22775Z0C00 or 22775AA060, connect the Select Monitor to the vehicle's Diagnostic Link Connector (DLC) located in the vehicle's lower left dash panel.

Tools needed: Select Monitor, programming cable, P/N 22775Z0C00 or 22775AA060, and Select Monitor Reprogramming Cartridge P/N SOA635076.




















Important:
Only use the specified Select Monitor Programming Cable for reprogramming.