Programming and Relearning
REGISTRATION BODY INTEGRATED UNIT (EQUIPMENT SETTING)CAUTION: Body integrated unit is core of LAN system, and also can select the function of all vehicle system control. It is possible to control the original functions of vehicle when registrations of body integrated unit and function setting are corresponded to vehicle equipment.
If registrations and function setting are different from vehicle equipment, vehicle system does not operate normally and diagnosis cannot be performed correctly. Pay attention to following item.
- Be sure to correspond registrations and function settings to vehicle equipment.
- Do not change the settings of vehicle improperly.
- Confirm key illumination does not blink or "Factory initial setting" of body integrated unit registrations is Market. If "Factory initial setting" is set to "Factory", key illumination blinks with ignition key turned to ON to give warning of unconfirmed settings.
- Key illumination does not blink with ignition switch turned to ON and go off with door closed.
- Be sure to register immobilizer if body integrated unit is replaced with a new one. (Model with immobilizer)
- Make a registration of immobilizer when the parts related to immobilizer have been replaced. Refer to the REGISTRATION MANUAL FOR IMMOBILIZER.
- Do not install or register an immobilizer related module of other registered vehicles to diagnose failures or inspect functions.
1. Turn the ignition switch to OFF.
2. Connect the Subaru Select Monitor to data link connector.
3. Turn the ignition switch to ON and Subaru Select Monitor to ON.
4. On the <
5. On the <
6. Change the setting with UP/DOWN key and press the [YES] key.
Also, it is possible to set by changing to factory mode and pressing the wiper deicer switch, rear defogger switch, rear fog light switch and door lock switch.
NOTE: Center display yes/no can be set only by the select monitor.
- List of body integrated unit registration item
NOTE: Setting is different depending on grade of vehicle and what is equipped.
CAUTION:
- It is possible to control the original functions of vehicle when registrations of body integrated unit and function setting are corresponded to vehicle equipment.
- When body integrated unit is a new one or "Factory" mode, key illumination blinks to show equipment settings have not been completed.
- Be sure not to change Factory initial setting except installation of new body integrated unit.
NOTE:
"Factory" mode:
- Body integrated unit has not been set yet. It can be recognized by key illumination blinking with ignition switch turned to ON.
- All body integrated units as part for repair are set to "Factory" mode. When replacing a body integrated unit, be sure to perform the registration operation.
"Market" mode:
- Each settings have been set. It can be recognized by key illumination coming on in concocting with room light and going off with ignition switch turned to ON.
7. Perform the Factory setting. On the <
9. Register the immobilizer key.
10. Perform the registration according to the procedures of the "IMMOBILIZER REGISTRATION OPERATION".
11. When key registration is completed, Do you want to register remote engine start? is displayed. Select NO.
12. Perform the function setting (ECM customizing).
NOTE: For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION".