Read Diagnostic Trouble Code (DTC)

READ DIAGNOSTIC TROUBLE CODE (DTC)

NOTE:
- DTC is displayed in the sequence of inputting. (When inputting two DTCs or more simultaneously, they are displayed in the sequence of priority.)
- When more than two DTCs are displayed, perform the diagnosis of top of them.




1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.




3. Insert the cartridge to the Subaru Select Monitor.




4. Connect the Subaru Select Monitor to data link connector.
Data link connector is located in the lower portion of instrument panel (on the driver's side).

CAUTION: Do not connect the scan tools except for Subaru Select Monitor.




5. Turn the ignition switch to ON (engine OFF) and turn the Subaru Select Monitor switch to ON.
6. On the [[Main Menu]] display screen, select the {Each System Check} and press the [YES] key.
7. On the [[System Selection Menu]] display screen, select the {Integ. Unit mode} and press the [YES] key.
8. On the [[Integ. unit mode failure diag]] screen, select the {Diagnostic Code(s) Display} and press the [YES] key.

NOTE:
- It is possible to read the DTC at the {Check all diagnosis codes} on the [[Main Menu]], and then find the contents to check from the DTC table.
- For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION".
- For details concerning DTCs, refer to the List of Diagnostic Trouble Code (DTC). DTC List - B and U Codes