Engine Control Module: Service and Repair

Engine Control Module (ECM)

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the front pillar lower trim and console side panel lower RH of passenger's side.
3. Detach the floor mat of passenger's seat.




4. Remove the protect cover.
5. Remove the nuts which hold the ECM to the bracket.




6. Remove the clip (A) from bracket.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage on the fuel injection system.
- When replacing the ECM, be careful not to damage the harnesses and connectors.
- When replacing the ECM, immobilizer system must be registered. To do so, all ignition keys and ID cards need to be prepared.

Tightening torque: 5 N.m (0.5 kgf.m, 3.6 ft.lb)