Valve Rocker Assembly

Valve Rocker Assembly

REMOVAL
1. Remove V-belt.
2. Remove crankshaft pulley.
3. Remove timing belt cover.
4. Remove timing belt.
5. Remove camshaft sprocket.
6. Disconnect PCV hose and remove rocker cover.
7. Removal of valve rocker assembly





a Remove bolts (a) through (h) in alphabetical sequence.

NOTE: Leave two or three threads of bolts (9 and h) engaged to retain valve rocker assembly.





b Remove valve rocker assembly.

INSTALLATION
1. Installation of valve rocker assembly
a Temporarily tighten bolts (a) through (d) in alphabetical order equally as shown in figure.

NOTE: Do not allow valve rocker assembly to damage knock pins.

b Tighten bolts (e) through (h) in alphabetical order to specified torque.





c Tighten bolts (a) through (d) in alphabetical order to specified torque.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2. Adjust the valve clearances.
3. Install rocker cover and connect PCV hose.
4. Install camshaft sprocket.
5. Install timing belt.
6. Install timing belt cover.
7. Install crankshaft pulley.
8. Install V-belt.

DISASSEMBLY
1. Remove bolts which secure rocker shaft.
2. Extract rocker shaft. Remove valve rocker arms, springs, plates and shaft supports from rocker shaft.

NOTE: Arrange all removed parts in order so that they can be installed correctly in their original positions.

3. Remove nut and adjuster screw from valve rocker.

ASSEMBLY
1. Install adjuster screw and nut to valve rocker.
2. Arrange valve rocker arms, springs and shaft supports in assembly order and insert valve rocker shaft.
Tightening torque (Shaft supports installing bolts): 5 Nm (0.5 kgf-m, 3.6 ft. lbs.)

NOTE: Valve rocker arms, rocker shaft and shaft supports have identification marks. Ensure parts with same markings are properly assembled.

3. Install valve rocker shaft securing bolts.

INSPECTION

VALVE ROCKER ARM AND ROCKER SHAFT








1. Measure inside diameter of valve rocker arm and outside diameter of valve rocker shaft, and determine the difference between the two (= oil clearance).
Clearance between arm and shaft:
Standard 0.020 - 0.054 mm (0.0008 - 0.0021 inch)
Limit 0.10 mm (0.0039 inch)
2. If oil clearance exceeds the limit, replace valve rocker arm or shaft, whichever shows greater amount of wear.
Rocker arm inside diameter: 22.020 - 22.041 mm (0.8669 - 0.8678 inch)
Rocker shaft diameter: 21.987 - 22.000 mm (0.8656 - 0.8661 inch)
3. If cam or valve contact surface of valve rocker arm is worn or dented excessively, replace valve rocker arm.
4. Check that valve rocker arm roller rotates smoothly. If not, replace valve rocker arm.