V-Belt
V-beltREMOVAL
1. FRONT SIDE BELT
1. Remove the collector cover.
2. Loosen the lock bolt (A).
3. Loosen the slider bolt (B).
4. Remove the front side belt (C).
2. REAR SIDE BELT
1. Loosen the lock nut (A).
2. Loosen the slider bolt (B).
3. Remove the A/C belt.
4. Remove the belt tensioner.
INSTALLATION
1. FRONT SIDE BELT
CAUTION: Wipe off any oil or water on the belt and pulley.
1. Install the belt (c), and tighten the slider bolt (13) so as to obtain the specified belt tension.
2. Tighten the lock bolt (A).
3. Tighten the slider bolt (B).
Tightening torque:
Lock bolt through bolt. 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
Slider bolt 8 Nm (0.8 kgf-m, 5.5 ft. lbs.)
2. REAR SIDE BELT
1. Install a belt, and tighten the slider bolt (13) so as to obtain the specified belt tension.
2. Tighten the lock nut (A).
Tightening torque:
Lock nut (A); 22.6 Nm (2.3 kgf-m, 16.6 ft. lbs.)
INSPECTION
1. Replace the belts, if crack, fraying or wear is found.
2. Check the drive belt tension and adjust it if necessary by changing generator installing position and/or idler pulley installing position.
Belt tension (with belt tension gauge):
(A)
When installing new parts: 640 - 780 N (65 - 80 kgf, 144 - 175 lb)
At inspection: 490 - 640 N (50 - 65 kgf, 110 - 144 lb)
(B)
When installing new parts: 740 - 880 N (76 - 89 kgf, 167 - 197 lb)
At inspection 350 - 450 N (36 - 46 kgf, 78 - 101 1b)
Model with air conditioner
Belt tension (without belt tension gauge):
(A)
When installing new parts: 7 - 9 mm (0.276 - 0.354 inch)
At inspection 9 - 11 mm (0.354 - 0.433 inch)
(B)
When installing new parts: 7.5 - 8.5 mm (0.295 - 0.335 inch)
At inspection 9.0 - 10.0 mm (0.354 - 0.394 inch)
Model with air conditioner