With Manufacturer's Scan Tool
Clear Memory ModeOPERATION
1. SUBARU SELECT MONITOR (NORMAL MODE)
1. On the "Main Menu" display screen, select {Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type has been displayed.
4. On the "Engine Diagnosis" display screen, select {Clear Memory} and press the [YES] key.
5. When the "Done" is shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
2. SUBARU SELECT MONITOR (OBD MODE)
1. On the "Main Menu" display screen, select {Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type has been displayed.
4. On the "Engine Diagnosis" display screen, select {OBD System} and press the [YES] key.
5. On the "OBD Menu" display screen, select {DTC Clear} and press the [YES] key.
6. When the "Perform Diagnostic Code(s) Clear?" is shown on the screen, press the [YES] key.
7. Turn the ignition switch to OFF and then turn the Subaru Select Monitor switch to OFF.
NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".