With Manufacturer's Scan Tool

READ DIAGNOSTIC TROUBLE CODE(DTC)
When malfunction of airbag system occurs, the DTC stored in airbag control module will be readout.

1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to the Subaru Select Monitor.

3. Insert the cartridge to the Subaru Select Monitor.
4. Connect the Subaru Select Monitor to the data link connector.

1. The data link connector is located in the lower portion of the instrument panel (on the driver's side).
2. Connect the diagnosis cable to the data link connector.

CAUTION: Do not connect scan tools other than the Subaru Select Monitor.

5. Turn the ignition switch to ON (engine OFF) and turn the Subaru Select Monitor switch to ON.
6. On the <

> display screen, select {Each System Check} and press the [YES] key.
7. On the <> display screen, select the {Airbag System} and press the[YES] key.
8. {Press the [YES] key after the {**MY AIRBAG SYSTEM} is displayed.
9. On the <> screen, select the {DTC Display}, and then press the [YES] key.

NOTE:
- For details concerning operation procedures, refer to the "SUBARU SELECT MONITOR OPERATION".
- For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC). Airbag System (Diagnostics)