Check Battery Disconnect Protection
CHECK BATTERY DISCONNECT PROTECTION1. Remove the key from the ignition switch.
2. Close all doors and the rear gate.
3. Open the front hood.
4. Press the LOCK/ARM button of the transmitter.
5. Disconnect the ground cable from the battery.
6. Reconnect the cable to the battery.
7. Check that the security indicator light blinks after reconnecting the battery cable.
If NG, replace the keyless entry control unit.
SECURITY SYSTEM ON/OFF SETTING
1. Close all doors and rear gate, sit down on the driver seat. Press the UNLOCK button of transmitter.
2. Turn the ignition switch to ON.
3. Press the centralized door lock switch to UNLOCK side and open the driver's door simultaneously, and maintain this state for 10 seconds.
4. The setting of security system (ON <-> OFF) will be switched, and the horn sounds.
NOTE: Refer to the following for the ON/OFF setting of security system using Subaru Select Monitor.