Rear Door: Service and Repair

REAR DOOR

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the rear door trim.
3. Remove the rear door glass.
4. Remove the rear door regulator and motor assembly.
5. Remove the rear door latch.
6. Remove the rear outer handle.
7. Remove the connection of rubber dust (A) from center pillar, pull out the connector of door harness to separate.

8. Put a wooden block on the jack and place the jack under the rear door. Support the rear door with jack to protect it.

NOTE: When supporting the door with jack, do not deform the hinge portion of door during work.

9. Remove the checker bolts.

10. Remove the door-side bolts for upper and lower hinges to remove the rear door panel.

INSTALLATION

1. Install in the reverse order of removal.
2. Apply grease to the sliding area of door hinges.

Tightening torque:
Refer to COMPONENT in General Description.