With Manufacturer's Scan Tool

Clear Memory Mode

OPERATION

MANUFACTURER'S SCAN TOOL (NORMAL MODE)
1. On the Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On the System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the Engine Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the Done and Turn Ignition Switch OFF are shown on the display screen, turn the ignition switch to OFF, and then turn the Manufacturer's scan tool to OFF.

NOTE: For detailed operation procedure, refer to MANUFACTURER'S SCAN TOOL OPERATION MANUAL.

MANUFACTURER'S SCAN TOOL (OBD MODE)
1. On the Main Menu display screen, select the {Each System Check} and press the [YES] key.
2. On the System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the Engine Diagnosis display screen, select the {OBD System} and press the [YES] key.
5. On the OBD Menu display screen, select the {Diagnosis Code(s) Cleared} and press the [YES] key.
6. When the Clear Diagnostic Code? is shown on the display screen, press the [YES] key.
7. Turn the ignition switch to OFF, and then turn the Manufacturer's scan tool to OFF.

NOTE: For detailed operation procedure, refer to MANUFACTURER'S SCAN TOOL OPERATION MANUAL.