Keyless Entry Transmitter: Service and Repair
TransmitterREMOVAL
1. TRANSMITTER BATTERY
Remove the battery (1) from the transmitter.
NOTE: To prevent static electricity damage to the transmitter printed circuit board, touch the steel area of building with hand to discharge static electricity carried on body or clothes before disassembling the transmitter.
INSTALLATION
1. TRANSMITTER BATTERY
Install in the reverse order of removal.
INSPECTION
1. TRANSMITTER BATTERY
Measure the voltage between the keyless transmitter battery (+) terminal and (-) terminal.
NOTE:
Battery discharge occurs during the measurement. Complete the measurement within 5 seconds.
If NG, replace the battery. (Use CR2025 or equivalent.)
REPLACEMENT
1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR
NOTE:
- A maximum of four keyless transmitter can be registered for each individual vehicle.
- When replacing or adding the keyless transmitter, new registration of transmitter is necessary.
1. Connect the Subaru Select Monitor to the vehicle.
2. Turn the ignition switch to ON.
3. From the �Main menu� on the Subaru Select Monitor, select the {2. Check individual system} {7. Integrated unit mode} {8. Transmitter ID registration}, and press the [YES] key.
4. Input the 8-digit ID number fund inside the plastic bag that the transmitter came in, or inside the transmitter, from left to right. Press the [YES] key.
NOTE: Press the [/\ ] key on the Subaru Select Monitor to increase the number, and the [\/ ] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.
5. The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag.
6. Press the [YES] key if the ID number is correct. Press the [NO] key if incorrect, to return to the step 3) and try again.
7. <
8. >>ID registration done>> will be displayed when the registration process is done.
9. To exit, select <
NOTE:
- If the registration fails, <
- <