Without Scan Tool

CLEAR MEMORY MODE

OPERATION

1. ECM

1. On the [[Main Menu]] display screen, select the {Each System Check} and press the [YES] key.
2. On the [[System Selection Menu]] display screen, select the {Engine} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the [[Engine Diagnosis]] display screen, select the {Memory Clear} and press the [YES] key.
5. When the Done are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON. Wait for 3 seconds before starting the engine.
- For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION".

2. BODY INTEGRATED UNIT

1. On the [[Main Menu]] display screen, select the {Each System Check} and press the [YES] key.
2. On the [[System Selection Menu]] display screen, select the {Integ. unit mode} and press the [YES] key.
3. Press the [YES] key after the {Integ. unit mode} is displayed.
4. On the [[Integ. unit mode failure diag]] display screen, select the {Clear Memory} and press the [YES] key.
5. When the Done are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION".