Operation CHARM: Car repair manuals for everyone.

Removal and Installation

Second-row Seats

REMOVAL

1. LH & CTR SEAT
1. Tilt the backrest forward, and move the seat forward.
2. Remove the slide rail cover at the seat rear side, and remove the two bolts.
3. Move the seat to the rear end.




4. Remove the slide rail cover at the seat front side, and remove the two bolts.
5. Remove the seat from vehicle.

2. RH SEAT
1. Tilt the backrest forward, and move the seat forward.
2. Remove the slide rail cover at the seat rear side, and remove the two bolts.
3. Move the seat to the rear end.




4. Remove the slide rail cover at the seat front side, and remove the two bolts.
5. Remove the seat from vehicle.

INSTALLATION
Install in the reverse order of removal.

Second-Row Seats:






Tightening torque: Nm (kgf-m, ft-lb)
T1: 6 (0.61, 4.43)
T2: 17.6 (1.79, 12.7)
T3: 52 (5.30, 37.6)
T4: 53 (5.40, 38.3)


NOTE: Tighten the slide rail bolts diagonally in two or three steps by gradually increasing the torque, until they reach the specified torque.