Subaru Select Monitor

Subaru Select Monitor

OPERATION

READ DIAGNOSTIC TROUBLE CODE (DTC)
1. Prepare the Subaru Select Monitor kit.





2. Connect the diagnosis cable to Subaru Select Monitor.
3. Insert the cartridge to the Subaru Select Monitor.





4. Connect the Subaru Select Monitor to data link connector.
1. Data link connector is located in the lower portion of instrument panel (on the driver's side).





2. Connect the diagnosis cable to data link connector.

CAUTION: Do not connect the scan tools except for Subaru Select Monitor.

5. Turn the ignition switch to ON (engine OFF) and turn the Subaru Select Monitor switch to ON.





6. On the �Main Menu� display screen, select the {Each System Check} and press the [YES] key.
7. On the �System Selection Menu� display screen, select the {Brake Control} and press the [YES] key.
8. Press the [YES] key after the {VDC AWD AT} is displayed.
9. On the �VDC Diagnosis� screen, select the {Diagnostic Code(s) Display}, and then press the [YES] key.

NOTE:
^ For details concerning operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
^ For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC). DTC List - C Codes
^ DTCs are displayed up to three in detected order.

10. If VDC and Subaru Select Monitor cannot communicate, check the communication circuit.





READ CURRENT DATA
1. On the �Main Menu� display screen, select the {Each System Check} and press the [YES] key.
2. On the �System Selection Menu� display screen, select the {Brake Control} and press the [YES] key.
3. Press the [YES] key after {VDC AWD AT} is displayed.
4. On the �Brake Control Diagnosis� display screen, select the {Current Data Display/Save}, and then press the [YES] key.
5. On the �Display Menu� screen, select the data display method and press the [YES] key.
6. Using a scroll key, scroll the display screen up or down until necessary data is shown.
^ A list of the support data is shown in the following table.





NOTE: For details concerning operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

CLEAR MEMORY MODE
1. On the �Main Menu�, select the {2. Each System Check} and press the [YES] key.
2. On the �System Selection Menu� display screen, select the {Brake Control} and press the [YES] key.
3. Press the [YES] key after {VDC AWD AT} is displayed.
4. On the �Brake Control Diagnosis� display screen, select the {Memory Clear} and press the [YES] key.





5. When Done and Turn ignition switch OFF are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE: For details concerning operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

SEQUENCE CONTROL





FREEZE FRAME DATA

NOTE:
^ Data stored at the time of trouble occurrence is shown on display.
^ Each time trouble occurs, the latest information is stored in the freeze frame data in memory.