Operation CHARM: Car repair manuals for everyone.

Clearing Trouble Codes

CLEAR MEMORY MODE

NOTE: To clear the previous DTC, use {Clear Memory}, and to clear the learned value, use {Clear Memory 2}.

1. Check that the select lever is in P range.
2. On the �Main Menu� display screen, select the {Each System Check} and press the [YES] key.
3. On the �System Selection Menu� display screen, select the {Transmission} and press the [YES] key.
4. Press the [YES] key after the information of transmission type is displayed.
5. On the �Transmission Diagnosis� display screen, select the {Clear Memory} and press the [YES] key.

NOTE: If {Clear Memory 2} is selected and performed, DTC are not cleared.

6. When 'Done' is shown on the display screen, turn off the Subaru Select Monitor and turn the ignition switch to OFF. To turn the ignition switch to ON again, wait for more than 10 seconds.