Operation CHARM: Car repair manuals for everyone.

Read Diagnostic Trouble Code (DTC)

READ DIAGNOSTIC TROUBLE CODE (DTC)
1. Prepare the Subaru Select Monitor kit.





2. Connect the diagnosis cable to Subaru Select Monitor.
3. Insert the cartridge to Subaru Select Monitor.





4. Connect the Subaru Select Monitor to data link connector.
1. Data link connector is located in the lower portion of instrument panel (on the driver's side).





2. Connect the diagnosis cable to data link connector.

NOTE: Do not connect scan tools except for Subaru Select Monitor.

5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.





6. On the �Main Menu� display screen, select the {Each System Check} and press the [YES] key.
7. On the �System Selection Menu� display screen, select the {Transmission} and press the [YES] key.
8. Press the [YES] key after the information of transmission type is displayed.
9. On the �Transmission Diagnosis� screen, select the {DTC Display}, and then press the [YES] key.

NOTE:
^ For details concerning operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL .
^ For details concerning the diagnostic trouble codes (DTC), refer to the List of DTC. List of Diagnostic Trouble Code (DTC)