Brake Light Switch: Service and Repair
Stop Light SwitchREMOVAL
1. Disconnect the ground cable from the battery.
2. Disconnect the stop light switch connector.
3. Loosen the nuts, unscrew the stop light switch, and remove stop light switch.
INSTALLATION
1. Install the stop light switch onto the bracket with screws and position it with the nut.
2. Adjust the stop light switch position, and then tighten the nut.
INSPECTION
1. If the stop light switch does not operate properly (or if it is not secured at the specified position), replace with a new part.
2. Measure the clearance between the threaded end of the stop light switch and the stopper.
CAUTION: Be careful not to rotate the stop light switch.
3. If it is not within the specification, adjust it by adjusting the position of the stop light switch.
CAUTION: Be careful not to rotate the stop light switch.