Subaru Select Monitor

SUBARU SELECT MONITOR

OPERATION
1. HOW TO USE SUBARU SELECT MONITOR
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to the Subaru Select Monitor.




3. Connect the Subaru Select Monitor to the data link connector.
1. Data link connector is located in the lower portion of the instrument panel (on the driver's side).
2. Connect the diagnosis cable to the data link connector.

CAUTION: Do not connect scan tools other than the Subaru Select Monitor.

4. Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
5. Using the Subaru Select Monitor, call up DTCs and various data, then record them.

2. READ DIAGNOSTIC TROUBLE CODE (DTC) FOR THE ENGINE

Refer to "Read Diagnostic Trouble Code" for information about how to indicate DTC. Reading Diagnostic Trouble Codes

3. COMMUNICATION LINE CHECK

NOTE: The communication line between ECM and immobilizer control module can be checked in "System Operation Check Mode". This is referred to as "Communication line check".

1. Connect the Subaru Select Monitor.
2. On the Main Menu display screen, select {Each System Check}.
3. On the System Selection Menu display screen, select {Engine}.
4. Select the [OK] after the information of engine type is displayed.
5. On the Engine Diagnosis display screen, select {System Operation Check Mode}.
6. On the System operation check mode display, select the {security system}.
7. Start the communication line check.
8. Is OK displayed on screen?

If displayed, go to step 9).

If not, go to step 10).

9. After diagnostic results, it is determined that the circuit is not shorted. Finish the communication line check.
10. If a problem is detected, repair the trouble cause.