Real-Time Diagnosis

REAL-TIME DIAGNOSIS

1. Connect the Subaru Select Monitor.
2. Turn the ignition switch and cruise control main switch to ON.
3. Connect the Subaru Select Monitor.
4. Select {2. Each System Check} in the Main Menu screen.
5. Select {Engine Control System} in the System Selection screen.
6. Select [OK] after the information of engine type has been displayed.
7. Select {Current Data Display & Save} in the Engine Control System Diagnosis screen.
8. Make sure that normal display is shown when operated as follows:
- Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.)
- Turn the SET/COAST switch to ON.
- Turn the "RES/ACC" switch to ON.
- Turn the CANCEL switch to ON. (The SET/COAST switch and the RES/ACC turn to ON simultaneously.)
- Depress or release the clutch pedal. (MT model)
- Place the shift lever in neutral position. (MT model)
- Move the select lever to "P" or "N" range. (AT model)

NOTE:
- For details concerning the operation procedures, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
- For the DTC, refer to the List of Diagnostic Trouble Code (DTC). Cruise Control - Diagnostics