Read Diagnostic Trouble Code (DTC)

READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.





2) Connect the diagnosis cable to Subaru Select Monitor.
3) Insert the cartridge to Subaru Select Monitor.





4) Connect the Subaru Select Monitor to data link connector.
(1) Data link connector is located in the lower portion of the instrument panel (on the driver's side).





(2) Connect the diagnosis cable to data link connector.

CAUTION:
Do not connect the scan tools except for Subaru Select Monitor or general scan tool.

5) Turn the ignition switch to ON (engine OFF) and turn the Subaru Select Monitor power switch to ON.





6) On the "Main Menu" display screen, select the (Each System Check) and press the [YES] key.
7) On the "System Selection Menu" display screen, select the (Transmission) and press the [YES] key.
8) Press the [YES] key after the (Center Differential Control) is displayed.
9) On the "Transmission Diagnosis" display screen, select the (DTC Display) and press the [YES] key.

NOTE:
^ For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION".
^ For details concerning DTCs, refer to the "List of Diagnostic Trouble Code (DTC)". List of Diagnostic Trouble Code (DTC)
10) If transmission and Subaru Select Monitor cannot communicate, check the communication circuit.
11) On the "Check DTC" display screen, select the (Latest Code) or (Memory Code) and press the [Yes] key.