Tire Monitoring System: Service and Repair
REGISTER TRANSMITTER IDPerform the procedures below to register the transmitter if.
^ Transmitter replaced.
^ Switched the position of the transmitter (rotated tires).
^ Replaced the tire pressure monitoring control module.
NOTE:
If registration of the transmitter ID is not possible after 2 attempts, replace the tire pressure monitoring control module.
If the ignition switch is turned to OFF or the Subaru Select Monitor is shut down while registering the transmitter, or if registration is not possible for more than 5 minutes, the registration mode is cancelled.
When rotating tires, there is no affect on the performance or functions of the tire pressure monitoring control module even if the transmitter (ID) is not registered, however, the tire position displayed on the Subaru Select Monitor will be incorrect.
1. Adjust all tire pressures to the specifications.
NOTE:
Refer to the tire caution label on the driver's side door for the correct tire pressure.
2. Connect the Subaru Select Monitor, on the Main Menu display screen, select the {2. Each System Check}.
3. On the System Selection Menu display screen, select the {Tire Pressure Monitor}.
4. Select the [OK] after the {Tire Pressure Monitor} is displayed.
5. On the �Tire Pressure Monitor Diagnosis� display screen, select the {Transmitter ID regist confirm}.
6. When ID registration mode execute, Registered ID is deleted Proceed? is displayed then select the [OK].
7. Touch the transmitter registration tool to the side wall area near the air valve on the front left tire, and press the switch. The transmitter ID is sent to the tire pressure monitoring control module. (At that time, the tire pressure warning light blinks to confirm that the registration has started.)
NOTE:
^ Register the transmitter ID in the order of Left Front Right
^ Front Right Rear Left Rear.
^ The transmitter registration tool is used by touching the side wall area near the transmitter.
^ When registration of each tire is completed, the hazard light will blink and {ID registration completed} is displayed on the Select Monitor screen.If registration procedure stop in the halfway (turning ignition switch to OFF, wrong registration order, etc.), proceed from step
8. When ID registration is completed, the tire pressure warning light remains lit for approximately 2 seconds, to end the registration. Switch to the screen displaying the transmitter ID on the Subaru Select Monitor display.
9. Check the transmitter ID that was registered, then perform a driving test.
DISPLAY TRANSMITTER (ID).
1. On the Main Menu display screen, select {Each System Check}.
2. On the �System Selection Menu� display screen, select the {Tire Pressure Monitor}.
3. Select the [OK] after the {Tire Pressure Monitor} is displayed.
4. On the �Tire Pressure Monitor Diagnosis� display screen, select the {Transmitter ID regist confirm}.
5. Select {Transmitter ID Data Monitor} to display the transmitter ID.
DRIVING TEST PROCEDURE
Reproduce the malfunction occurrence condition as possible. Drive the vehicle at a speed more than 40 km/h (25 MPH) for at least ten minutes.