Front Speed Sensor
Front Vehicle Speed SensorREMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Remove the air intake chamber.
4. Disconnect the transmission connector.
5. Remove the pitching stopper.
6. Remove the transmission connector from the stay.
7. Lift-up the vehicle.
8. Clean the transmission exterior.
9. Remove the ATF drain plug to drain ATF.
CAUTION: After running the engine or after idling for a long time, the ATF is hot. Be careful not to burn yourself.
10. Tighten the ATF drain plug.
NOTE: Use a new gasket.
Tightening torque: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)
11. Remove the front, center and rear exhaust pipes and muffler.
12. Remove the shield cover.
13. Remove the propeller shaft.
14. Place the transmission jack under transmission.
NOTE: Make sure that the support plates of transmission jack does not touch the oil pan.
15. Remove the transmission rear crossmember bolt.
16. Lower the transmission jack.
NOTE: Do not separate the transmission jack and transmission.
17. Remove the oil cooler inlet and outlet pipes.
NOTE: When removing the outlet pipe, be careful not to lose the ball and spring used with retaining screw.
18. Remove the front vehicle speed sensor and torque converter turbine speed sensor.
19. Disconnect the connector from rear vehicle speed sensor.
20. Remove the oil pan.
21. Disconnect the harness connector and transmission ground terminal.
22. Remove the harness assembly.
INSTALLATION
1. Pass the harness assembly through the hole in transmission case.
2. Connect the harness connector and transmission ground.
Tightening torque: 8 Nm (0.8 kgf-cm, 5.8 ft. lbs.)
3. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)
4. Apply liquid gasket fully to the three holes other than screw holes on the transmission case
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)
5. Install the oil pan.
Tightening torque: 5 Nm (0.5 kgf-cm, 3.6 ft. lbs.)
6. Install the front vehicle speed sensor and torque converter turbine speed sensor.
Tightening torque: 7 Nm (0.7 kgf-cm, 5.1 ft. lbs.)
7. Connect the connector to rear vehicle speed sensor.
8. Install the oil cooler pipe.
NOTE: Use a copper washer.
Tightening torque:
T1: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)
T2: 44 Nm (4.5 kgf-cm, 32.5 ft. lbs.)
9. Install the transmission rear crossmember bolt.
Tightening torque: 75 Nm (7.6 kgf-cm, 55 ft. lbs.)
10. Install the propeller shaft.
11. Install the shield cover.
12. Install the front, center and rear exhaust pipes and muffler
13. Lower the vehicle.
14. Install the transmission connector to the stay.
15. Install the pitching stopper.
16. Install the air intake chamber.
17. Fill the same amount of ATF, drained.
18. Bleed the air of control valve.
19. Check the level of ATF.
20. Execute the learning control promotion.