Crossbar

CROSSBAR

Crossbar:

REMOVAL

1. Remove the TORX(R) bolt T30 from each end support.
2. Rotate the lower clamp of each end support about 90° downward to remove the crossbar.






CAUTION: Pay attention to avoid damage to the roof panel during removal or installation.

INSTALLATION

1. Rotate the lower clamp of each end support about 90° downward.
2. Set the front crossbar so that front direction mark on the right side top face of crossbar point in the direction of vehicle front.
3. Place the crossbar end support in a position 76.2 mm (3 in) behind the joint of front roof rail support and roof rail.






4. Set the rear crossbar so that front direction mark on the right side top face of crossbar point in the direction of vehicle front.
5. Place the crossbar end support on a joint of rear roof rail support and roof rail.






6. lighten the end support and clamp using TORX(R) bolt T30.