Displaying and Reading Trouble Codes - With ABS
Subaru Select MonitorOPERATION
1. READ DIAGNOSTIC TROUBLE CODE (DTC)
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.
3. Insert the cartridge into Subaru Select Monitor.
4. Connect the Subaru Select Monitor to data link connector.
1. Data link connector located in the lower portion of instrument panel (on the driver's side).
2. Connect the diagnosis cable to data link connector.
CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor power switch to ON.
6. On the [[Main Menu]] display screen, select the (Each System Check) and press [YES] key.
7. On the [[System Selection Menu]] display screen, select the (Brake Control System) and press [YES] key.
8. Press the [YES] key after the information of engine type is displayed.
9. On the [[ABS Diagnosis]] display screen, select the (DTC Display) and press [YES] key.
10. On the [[DTC Display]] display screen, select the (Current DTC) or (History DTC) and press [YES] key.
NOTE:
^ For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
^ For detailed concerning the DTC, refer to the LIST OF DTC.
^ A maximum of 3 DTCs are displayed in order of occurrence.
^ If a particular DTC is not properly stored in memory (due to a drop in ABSCM&H/U power supply, etc.) when a problem occurs, the DTC, followed by a question mark "T" appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
2. READ CURRENT DATA
1. On the [[Main Menu]] display screen, select the (Each System Check) and press [[YES]] key.
2. On the [[System Selection Menu]] display screen, select the (Brake Control System) and press [[YES]] key.
3. Press the [[YES]] key after the information of ABS type is displayed.
4. On the [[Brake Control Diagnosis]] display screen, select the (Current Data Display & Save) and press [[YES]] key.
5. On the [[Data Display Menu]] display screen, select the (Data Display) and press [[YES]] key.
6. Using the scroll key, move the display screen up or down until desired data is shown.
^ A list of the support data is shown in the following table.
NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
3. CLEAR MEMORY MODE
1. On the [[Main Menu]] display screen, select the (2. Each System Check) and press [[YES]] key.
2. On the [[System Select Menu]] display screen, select the (Brake System) and press [[YES]] key.
3. Press the [[YES]] key after the information of engine type is displayed.
4. On the [[Brake Control Diagnosis]] display screen, select the (Clear Memory) and press [[YES]] key.
5. When the "Done" and "turn ignition switch to OFF" are shown on display screen, turn the Subaru Select Monitor power switch and ignition switch to OFF.
NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
4. ABS SEQUENCE CONTROL
5. FREEZE FRAME DATA
NOTE:
^ Data stored at the time of trouble occurrence is shown on display.
^ Each time trouble occurs, the latest information is stored in the freeze frame data in memory.
^ Freeze frame data will be memorized maximum to three.
^ If freeze frame data is not properly stored in memory (due to a drop in ABSCM power supply, etc.), a DTC, preceded by a question mark "?", appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
