Radiator Cooling Fan: Service and Repair

RADIATOR AND RADIATOR FAN





9. Radiator Main Fan and Fan Motor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Lift-up the vehicle.
4. Remove the under cover.
5. Disconnect the connector of main fan motor (A).





6. Remove the ATF hose from clip of radiator main fan motor assembly. (AT model)
7. Lower the vehicle.
8. Disconnect the overflow hose.
9. Remove the reservoir tank.
10. Remove the bolts which secure the radiator main fan shroud to radiator.





11. Remove the radiator fan motor assembly.

INSTALLATION
Install in the reverse order of removal.

NOTE:
^ If it is difficult to install the radiator main fan motor assembly, first loosen the bolts which hold the radiator sub fan motor assembly.
^ Refer to COMPONENT for tightening torque.

DISASSEMBLY
1. Remove the nut which holds the fan onto fan motor.





2. Remove the bolts which install the fan motor onto shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 4.4 Nm (0.45 kgf-m, 3.3 ft. lbs.)





Tightening torque: 3.4 Nm (0.35 kgf-m, 2.5 ft. lbs.)





10. Radiator Sub Fan and Fan Motor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Lift-up the vehicle.
4. Remove the under cover.
5. Disconnect the connector of sub fan motor (B).





6. Remove the ATF hose from clips of radiator sub fan motor assembly. (AT model)
7. Lower the vehicle.
8. Remove the air intake duct.
9. Remove the bolts which hold the radiator sub fan shroud to radiator.





10. Remove the radiator sub fan motor assembly through the under side of vehicle.

INSTALLATION
Install in the reverse order of removal.

NOTE: Refer to COMPONENT for tightening torque.

DISASSEMBLY
1. Remove the clip which holds the motor connector onto shroud.
2. Remove the nut which holds the fan onto fan motor.





3. Remove the bolts which install the fan motor onto shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 4.4 Nm (0.45 kgf-m, 3.3 ft. lbs.)





Tightening torque: 3.4 Nm (0.35 kgf-m, 2.5 ft. lbs.)