Oil Pressure Sender: Service and Repair

Oil Pressure Switch

Removal
1. Remove the generator from bracket.
2. Disconnect the terminal from oil pressure switch.





3. Remove the oil pressure switch.





Installation
1. Apply liquid gasket to the oil pressure switch threads.
^ Liquid gasket. THREE BOND 1324 (Part No. 004403042) or equivalent





2. Install the oil pressure switch onto engine block.
^ Tightening torque: 25 Nm (2.5 kgf-m, 8.1 ft. lbs.)





3. Connect the terminal of oil pressure switch.





4. Install the generator on bracket.

Inspection
1. Make sure oil does not leak or seep from the place where the oil pressure switch is installed.