Headlamp Bulb: Service and Repair

HEADLIGHT BULB

REMOVAL

1. HIGH BEAM AND HALOGEN TYPE LOW BEAM

CAUTION:
- Because the halogen bulb operates at a high temperature, dirt and oil on the bulb surface reduces the bulb s service life. Hold the flange portion when replacing the bulb. Never touch the glass portion.
- Do not leave the headlight without a bulb for a long time. Dust, moisture, etc. entering the headlight may affect its performance.

1 Disconnect the ground cable from battery.




2 Remove the air intake duct (A) (when right side headlight bulb is removed).
3. Disconnect the harness connector.




4. Remove the bulb assembly. To remove the low beam, remove the back cover and go to Step 5.




5. Remove the light bulb retaining spring (A) to remove the bulb.

2. HID TYPE LOW BEAM

CAUTION:
- Do not operate with wet hands.
- As the lightening circuit uses high voltage, be sure to confirm that the power supply is turned off before operation.
- When replacing the bulb, hold the flange portion and never touch the glass portion.
- Do not leave the headlight without a bulb for a long time. Dust, and moisture, etc. entering the headlight may affect its performance.

1. Remove the ground cable from battery.
2. Remove the headlight assembly.




3. Remove the back cover.




4. Disconnect the harness connector.




5. Remove the light bulb retaining spring, and then remove the bulb.

INSTALLATION
Install in the reverse order of removal.

CAUTION: Attach the rubber cap with letters TOP on the top so the drain hole will be on the lower side.