Operation CHARM: Car repair manuals for everyone.

Inhibitor Switch

Inhibitor Switch

INSPECTION
When the driving condition or starter motor operation is erroneous, first check the shift linkage for improper operation. If the shift linkage is functioning properly, check the inhibitor switch.
1) Disconnect the inhibitor switch connector.
2) Check continuity in inhibitor switch circuits with the select lever moved to each position.

NOTE:
^ Also check that continuity in ignition circuit does not exist when the select lever is in "R", "D", "3", "2" and "1" ranges.
^ If the inhibitor switch is inoperative, check for poor contact of connector on transmission side.








3) Check if there is continuity at equal points when the select lever is tilted 1.5° in both directions from "N" range.
If there is continuity in one direction and the continuity in the other or if there is continuity at unequal points, adjust the inhibitor switch.





4) Repeat the above checks. If there are abnormalities, adjust the select cable.

REMOVAL
1) Set up the vehicle on a lift.
2) Move the select lever to "N" range.
3) Remove the air intake chamber (Non-turbo model).
4) Remove the intercooler. (Turbo model)
5) Disconnect the inhibitor switch connector.





6) Remove the inhibitor switch connector from stay.
7) Lift-up the vehicle.
8) Remove the front and center exhaust pipes.
9) Remove the snap pin and washer from range select lever.





10) Remove the plate assembly from transmission case.





11) Remove the bolts.





12) Move the range select lever to parking position (left side).





13) Remove the inhibitor switch from transmission.





14) Disconnect the inhibitor switch harness connector from inhibitor switch.

INSTALLATION
1) Connect the inhibitor switch harness connector to inhibitor switch.

2) Install the inhibitor switch to transmission case.





3) Move the range select lever to neutral position.
4) Using the ST, tighten the bolts of inhibitor switch.
ST 499267300 STOPPER PIN





5) Install the select cable to range select lever.
6) Install the plate assembly to transmission.





7) Install the washer and snap pin to range select lever.





8) Install the front and center exhaust pipes. (Non-turbo model)
9) Install the center exhaust pipe. (Turbo model)
10) Lower the vehicle.
11) Install the inhibitor switch connector from stay.
12) Connect the inhibitor switch connector.





13) Install the air intake chamber. (Non-turbo model)
14) Install the intercooler. (Turbo model)
15) Inspect the inhibitor switch.