Caution

CAUTION

1. If the seat cushion cover has been removed or replaced, be sure to perform the system calibration for occupant detection system after installing seat to the vehicle.
2. Never remove the occupant detection control module of occupant detection system (passenger's side only) or pressure sensor from seat cushion frame since the control module and occupant detection sensor are fixed to the seat cushion frame.
3. Do not replace the seat cushion pad as a single unit. Be sure to replace the seat cushion pad and frame assembly together. Since the seat cushion pad and cushion frame have been adjusted at factory, installing them together with parts for other vehicle or ones of other set may cause improper operation of occupant detection system.
4. If the seat cushion cover has been removed, be sure to replace wire on the seat cushion cover side with a new one. (Passenger's seat)
5. Never connect the battery in reverse polarity. The occupant detection system may be destroyed instantly.
6. Do not disconnect the battery terminals while the engine is running. A large counter electromotive force will be generated in the generator, and this voltage may damage electronic parts such as occupant detection control module.
7. Before disconnecting the connectors of each sensor and the control module, be sure to turn off the ignition switch and wait for more than 20 seconds. The occupant detection control module may be damaged.
8. Every related part of occupant detection system is a precision part. Do not drop them.

CAUTION:
- Airbag system connectors are colored yellow. Do not use the electrical test equipment on these circuits.
- Be careful not to damage the airbag system wiring harness when servicing the occupant detection system.
- Refer to the CAUTION for airbag system when repairing the occupant detection system.