Component Tests and General Diagnostics

AIRBAG CONNECTOR

PROCEDURE

1. BUCKLE SWITCH AND OCCUPANT DETECTION CONTROL MODULE

1. How to disconnect
1. Move the slide lock (A) in the direction of the arrow.




2. Disconnect the connector with the slide lock (A) moved.

CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.

2. How to connect




Holding the connector (A), and push it in carefully until a connecting sound is heard.

CAUTION: Be sure to insert the connector in until it is locked. Then pull it gently to make sure that it is locked.

2. DRIVER'S AIRBAG MODULE AND PRETENSIONER

1. How to disconnect




1. Using a flat tip screwdriver, pry the push lock upward to unlock.




2. Pull the connector to disconnect from driver's side airbag module assembly or retractor assembly.

2. How to connect




Connect the connector in reverse order of disconnecting. At this time, be sure to insert the push lock in until connecting sound is heard.

CAUTION:
- Be sure to insert the connector in until it is locked. Then pull it gently to make sure that it is locked.
- Be sure to push the push lock in securely.

NOTE: Connector can not be connected when the push lock is in lock position. To connect the connector, set the push lock to unlock position.

3. DRIVER'S AIRBAG (BETWEEN AIRBAG MAIN HARNESS AND ROLL CONNECTOR) AND PASSENGER'S AIRBAG

1. How to disconnect




1. Press in the slide lock (A) in the direction of arrow.




2. With the slide lock (A) pressed in, disconnect the connector.

CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.

2. How to connect




Holding the connector, push it in carefully until a connecting sound is heard.

CAUTION: Be sure to insert the connector in until it locks. Then pull it gently to make sure that it is locked.

4. SIDE AIRBAG

1. How to disconnect
1. Push the lock arm (A).




2. With the lock arm (A) pushed in, move the slide lock (B) in the direction of the arrow.




3. With the slide lock moved, release the lock arm (back to its original position), and disconnect the connector.

CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.

2. How to connect
Holding the connector, push it in carefully until a connecting sound is heard.

5. FRONT SUB-SENSOR, SIDE AIRBAG SENSOR, SEAT POSITION SENSOR LH

1. How to disconnect




Holding outer part (A), pull it in the direction of the arrow.

CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.

2. How to connect




Holding the connector, push it in carefully until a connecting sound is heard.

CAUTION:
- Outer (A) moves back, and so do not put your hand on the outer part.
- Be sure to insert the connector in until it locks. Then pull it gently to make sure that it is locked.