Gear Sensor/Switch: Service and Repair
Switches and HarnessREMOVAL
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1) Disconnect the ground cable from battery.
2) Remove the air intake duct and cleaner case. (Non-turbo model)
3) Remove the intercooler. (Turbo model)
4) Disconnect the connector of back-up light switch and neutral position switch.
^ Non-turbo model
Non-turbo model:
^ Turbo model
Turbo model:
5) Lift-up the vehicle.
6) Remove the back-up light switch and neutral position switch with harness.
INSTALLATION
1. BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH
1) Install the back-up light switch and neutral position switch with harness.
Tightening torque:
32.3 Nm (3.3 kgf-m, 23.8 ft. lbs.)
2) Connect the connector of back-up light switch and neutral position switch.
3) Install the air intake duct and cleaner case. (Non-turbo model) 4) Install the intercooler. (Turbo model)
5) Connect the battery ground cable to battery.
Neutral Switch & Backup Switch Testing
Switches and Harness
INSPECTION
BACK-UP LIGHT SWITCH
Inspect the back-up light switch.
NEUTRAL POSITION SWITCH
1) Turn the ignition switch to OFF.
2) Disconnect the connector of neutral position switch.
3) Measure the resistance between neutral position switch terminals.
Non-turbo model:
Non-turbo model:
Turbo model:
Turbo model:
^ Non-turbo model
Non-turbo model:
^ Turbo model
Turbo model:
4) Replace defective parts.