P0506
DTC P0506 IDLE AIR CONTROL SYSTEM RPM LOWER THAN EXPECTED1. OUTLINE OF DIAGNOSIS
Detect the malfunction that actual engine speed is not close to target engine speed during idling. Judge as NG when actual engine speed is not close to target engine speed during idling.
2. ENABLE CONDITION
Enable Conditions:
3. GENERAL DRIVING CYCLE
After 10 seconds from engine starting, perform diagnosis continuously at idling after warming up.
4. DIAGNOSTIC METHOD
Abnormality Judgment
Judge as NG when the continuous time of meeting the malfunction criteria below is 10 seconds • 3 times.
Time Needed for Diagnosis: 10 seconds • 3 time
Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.
Normality Judgment
Judge as OK and clear NG when the continuous time of meeting the malfunction criteria below becomes more than 10 seconds.
5. DTC CLEAR CONDITION
- When the OK idling cycle is completed 40 times in a row
- When "Clear Memory" is performed
6. MALFUNCTION INDICATOR LIGHT CLEAR CONDITION
- When the OK driving cycle is completed 3 times in a row
- When "Clear Memory" is performed
7. FAIL SAFE
- Judgment of heavy fuel: Not allowed to make the judgment of heavy fuel.
- Knock compensation:
- Knock compensation final advance/delay angle value = knock compensation value + whole learning compensation value + portional learning compensation value
- When normal: Knock compensation value = Fixed at 0 °CA.
- Failure: Knock compensation value (not equal to) Fixed at 0 °CA. (When knock: Max. 12 °CA retard)
- Whole learning compensation coefficient update not allowed.
- Portional learning zone compensation value calculation not allowed.
8. ECM OPERATION AT DTC SETTING
Memorize the freeze frame data. (For test mode $02)