> display screen, select {Each System Check}.
4. On the <> display screen, select {keyless unit mode}.
5. On the <> display screen, select {ECM customizing}.
6. Change the setting with UP/DOWN key and press the [YES] key.
- List of function setting item (ECM customizing)

7. After setting, make sure that vehicle equipment matches the changed settings in the {Current Data Display & Save}.

CAUTION:
- The above settings most match the actual vehicle equipment for proper operation.
- Do not change settings other than the above while setting equipment.
- When installing a new keyless unit, perform initial setting again.
- In passive mode, the system will automatically activate the security alarm but WILL NOT automatically lock the doors. Failure to lock the doors manually will result in a high security risk.

NOTE: For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".

8. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.

2. WARNING HISTORY NOTICE MODE
1. Turn the ignition switch to ON.
2. Indicator light will blink.

NOTE:
- If ALARM/WARNING occurs during the armed mode, the indicator light will flash at ignition OFF --> ON at the next DISARM.
- If ALARM/WARNING was not generated, the indicator light does not blink.
- If the warnings overlap, the warning with the largest number of blinks will have priority and will blink.
- For all ignition ON operation during DISARM mode, the indicator will blink, and the record is updated at the next ARM mode.