Clear Memory Mode

Clear Memory Mode

OPERATION

1. On the [[Main Menu]] display screen, select {Each System Check}.
2. On the [[System Selection Menu]] display screen, select the {Engine Control System}.
3. Select the [OK] after the information of engine type is displayed.
4. On the [[Engine Diagnosis]] display screen, select the {Clear Memory}.
5. When [[Done]] and [[Turn ignition switch to OFF]] is shown on the display screen, turn the ignition switch to OFF and finish the Subaru Select Monitor.

NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON. Wait for 3 seconds before starting the engine.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".