Removal and Replacement
FRONT BUMPERFront Bumper:
REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the six clips from underside of the bumper (both left and right).
3. Turn over the mud guard, and remove one inside clip that secure the front bumper to the fender.
4. Turn over the mud guard and disconnect the fog light connector.
5. Remove the seven clips.
6. Remove the bumper face side claws from guide bracket (A), and remove the bumper face.
CAUTION: Do not pull them by force. The bumper face side claws can be damaged.
NOTE: The bumper can be easily pulled out by removing in the order of (1) - (5) from the fender side while lifting the bumper face upward (B).
7. Remove the E/A foam from bumper beam.
NOTE: Do not apply excessive force to remove the E/A foam because it is easily damaged.
8. Remove the bumper beam.
9. Remove the 8 bolts and disassemble the front bumper beam.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: Refer to "COMPONENT" of "General Description".