Transmission Speed Sensor: Service and Repair
Vehicle Speed SensorREMOVAL
1) Disconnect the ground cable from the battery.
2) Lift up the vehicle.
3) Remove the front, center, rear exhaust pipes and muffler.
4) Disconnect the connector from vehicle speed sensor.
5) Turn and remove the vehicle speed sensor.
INSTALLATION
NOTE:
^ Discard the old vehicle speed sensor after removal, use a new sensor for the installation.
^ Make sure that there is no foreign matter on the sensor mounting.
^ Align the tip end of the key with the key groove on the end of speedometer shaft during installation.
1) Hand tighten the vehicle speed sensor.
2) Tighten the vehicle speed sensor using suitable tools.
Tightening torque: 5.9 N-m (0.6 kgf-m, 4.3 ft-lb)
3) Connect the connector to the vehicle speed sensor.
4) Install the front, center and rear exhaust pipes, and the muffler.
5) Lower the vehicle.
6) Connect the ground cable to the battery.
INSPECTION
Inspect the vehicle speed sensor.