Rear Axle Disassembly
DISASSEMBLY1) Using ST1 and ST2, remove the hub from the rear housing.
ST1 927080000 HUB STAND
ST2 927420000 HUB REMOVER
2) Remove the back plate from the rear housing.
3) Remove the outer and inner oil seals using a flat tip screwdriver.
4) Remove the snap ring using a flat tip screwdriver .
CAUTION: Be careful not to damage housing during removal.
5) Using ST1 and ST2, remove the bearing by pressing the inner race.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER
6) Remove the tone wheel bolts and remove the tone wheel from the hub.
7) Using ST, press the hub bolt out. ST 927080000 HUB STAND
CAUTION: Be careful not to hammer the hub bolts. This may deform the hub.
