Removal and Replacement
MT Gear Shift LeverREMOVAL
1) Set the vehicle on a lift.
2) Remove the gear shift knob.
3) Disconnect the ground cable from the battery.
4) Remove the console box.
5) Remove the clamp.
6) Remove the bushing and insulator assembly.
7) Remove the plate assembly from the vehicle body.
8) Lift up the vehicle.
9) Remove the rear exhaust pipe and muffler.
10) Remove the stay from transmission bracket.
11) Remove the rod from joint.
12) Remove the cushion rubber from vehicle body.
13) Remove the spring pin, and then extract the joint.
14) Lower the vehicle.
15) Remove the lever COMPL.
INSTALLATION
1) Install the joint to the transmission and secure with spring pin.
2) Insert the lever COMPL from room side.
NOTE: After inserting the rod and stay, temporarily put them onto transmission mount.
3) Lift up the vehicle.
4) Install the joint to the shifter arm.
5) Insert the spring pin.
6) Mount the cushion rubber on the body.
Tightening torque: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
11) Install the plate assembly to the vehicle body.
Tightening torque: 7.5 N-m (0.76 kgf-m, 5.5 ft-lb)
7) Connect the rod to the joint.
Tightening torque: 12 N-m (1.2 kgf-m, 8.9 ft-lb)
8) Connect the stay to the transmission bracket.
Tightening torque: 18 N-m (1.8 kgf-m, 13.0 ft-lb)
9) Install the rear exhaust pipe and muffler.
10) Lower the vehicle.
11) Install the plate assembly to the vehicle body.
Tightening torque: 7.5 N-m (0.76 kgf-m, 5.5 ft-lb)
12) Install the boot and insulator assembly to vehicle in the proper direction.
13) Install the clamp.
14) Install the console box.