Scan Tool Testing and Procedures

Subaru Select Monitor

OPERATION

1. HOW TO USE THE SUBARU SELECT MONITOR
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.
3. Connect the Subaru Select Monitor to the data link connector.
1. Data link connector is located in the lower portion of the instrument panel (on the driver's side).






2. Connect the diagnosis cable to data link connector.

CAUTION: Do not connect the scan tools other than the Subaru Select Monitor.

4. Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
5. Using the Subaru Select Monitor, call up DTCs and various data, then record them.

2. READ DIAGNOSTIC TROUBLE CODE (DTC) FOR THE ENGINE
Refer to "Read Diagnostic Trouble Code" for information about how to display a DTC. Read Diagnostic Trouble Code (DTC)

3. COMMUNICATION LINE CHECK

NOTE: The communication line between ECM and immobilizer control unit can be checked in "System Operation Check Mode". This is referred to as Communication line check .

1. Connect the Subaru Select Monitor.
2. On the [[Each system check]] display, select the {Engine Control System}.
3. Start the communication line check.
4. Is [[OK]] displayed on screen?
If displayed, go to step5).
If not, go to step 6).

5. After diagnostic results, it is determined that the circuit is not shorted. Finish the communication line check.
6. If a problem is detected, repair the trouble cause.