Operation CHARM: Car repair manuals for everyone.

Symptom Related Diagnostic Procedures

Security And Locks

1. BASIC DIAGNOSTIC PROCEDURE

NOTE:
- Turbo model is the model with immobilizer.
- Non-turbo model is the model without immobilizer.

Step 1-6:




Step 7-8:






2. CHECK BATTERY DISCONNECT PROTECTION
1. Remove the key from the ignition switch.
2. Close all the doors and rear gate.
3. Open the front hood.
4. Press the keyless transmitter LOCK/ARM button, and wait until the security indicator light blinks twice within 1 second in 1 second cycle.
5. Disconnect the ground cable from the battery.
6. Connect the ground cable to the battery.
7. Check that the security indicator light blinks twice within 1 second in 1 second cycle after connecting the battery ground cable.

If NG, replace the keyless entry control module.

3. SECURITY SYSTEM ON/OFF SETTING

NOTE: When steps 1) to 4) are performed with the security system setting ON, the security system setting is switched to OFF.

1. Close all doors and the rear gate, then sit down on the driver seat. Press the UNLOCK button of the keyless transmitter.
2. Turn the ignition switch to ON.
3. While turning the center door lock switch to UNLOCK, open the driver's door, and keep this condition for 10 seconds.
4. Switch the security system setting (ON - OFF), then the horn sounds.






NOTE: See the following for security system ON/OFF setting with the select monitor.

4. SYMPTOM CHART

Symptom Chart:






5. CHECK POWER SUPPLY AND GROUND CIRCUIT

Step 1-2:






6. CHECK DOOR SWITCH

Step 1-4:






7. CHECK SECURITY INDICATOR LIGHT CIRCUIT

Step 1-3:






8. CHECK THE HORN


Step 1-2:






9. CHECK HAZARD LIGHT OPERATION

Step 1-2:






10. CHECK INTERRUPT RELAY CIRCUIT

Step 1-3:






11. CHECK IGNITION SWITCH CIRCUIT

Step 1: