Front Door: Service and Repair

FRONT DOOR

REMOVAL

1. Disconnect the ground cable from the battery.
2. Remove the front door trim.
3. Remove the outer mirror assembly.
4. Remove the front sealing cover.
5. Remove the front door glass.
6. Remove the front door regulator and motor.
7. Remove the front door latch assembly.
8. Remove the front outer handle.
9. Remove the front pillar lower trim to disconnect connector from the body harness.

10. Put a wooden block on jack and place jack under the door. Support the door with a jack to protect it from damage.

NOTE: When supporting the door with jack, work carefully so that you do not deform the hinge portion of door during work.

11. Remove the checker bolts.

12. Remove the door-side bolts for upper and lower hinges to remove front door panel.

13. Remove the attaching bolts (on the body side) for the upper and lower hinges using the ST to remove the door hinges.

ST 925610000 WRENCH

INSTALLATION

1. Install in the reverse order of removal.
2. Apply grease to the moving part of door hinges.
3. Refer to "COMPONENT" of "General Description" for tightening torque.