Caution

CAUTION
1. If the seat cushion cover is removed or replaced, make sure to perform occupant detection system adjustment after installing the seat to the vehicle. Failure to do so may cause improper operation of the occupant detection system.
2. As the occupant detection control module and the occupant detection sensor of occupant detection system (passenger's seat only) is securely fixed to the seat cushion frame, never remove the occupant detection control module and pressure sensor from the seat cushion frame.
3. Do not replace the seat cushion pad by itself. Be sure to replace the seat cushion pad & frame assembly as a unit. The seat cushion pad and cushion frame are adjusted as a set at the time of manufacture. If parts from other vehicles or cushion pad and cushion frame of other set is used, the occupant detection system will not function properly.
4. If the seat cushion cover is removed, always replace the wires of the seat cushion cover with new wires.
5. Never connect the battery in reverse polarity. Failure to do so may immediately damage the occupant detection system.
6. Do not disconnect the battery terminals while the engine is running. A large counter electromotive force will be generated in the generator, and this voltage may damage electronic parts such as occupant detection control module etc.
7. Before disconnecting the connectors of each sensor and control module, be sure to turn the ignition switch to OFF and wait for 20 seconds or more. Occupant detection control module may be damaged.
8. Every part relating to occupant detection system is a precision part. Do not drop them.

CAUTION:
- Do not use the electrical test equipment on the airbag system circuits.
- Be careful not to damage the airbag system wiring harness when servicing the occupant detection system.
- Refer to cautions on airbag system when repairing occupant detection system.