Speedometer Gear
Speedometer GearREMOVAL
1) Remove the manual transmission assembly from the vehicle.
2) Remove the back-up light switch and the neutral position switch.
3) Remove the transfer case together with the extension case assembly.
4) Remove the transmission case.
5) Remove the vehicle speed sensor.
6) Remove the snap ring (outer) and pull out the speedometer driven gear. Next, remove the oil seal, speedometer shaft and washer.
INSTALLATION
1) Install the washer and speedometer shaft, and press-fit the oil seal with ST.
NOTE: If it is removed, use a new oil seal.
ST 899824100 or 499827000 PRESS
2) Install the vehicle speed sensor.
3) Install the speedometer driven gear and snap ring (outer).
NOTE: If it is removed, use a new snap ring.
4) Install the transmission case.
5) Install the transfer case together with the extension case assembly.
6) Install the back-up light switch and neutral position switch.
7) Install the manual transmission assembly to the vehicle.
INSPECTION
Check the speedometer driven gear, oil seal and speedometer shaft for damage. Replace if it is damaged.