Front Door Latch: Service and Repair

Front Door Latch and Door Lock Actuator Assembly

REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the front door trim.
3. Remove the wire from the front inner remote.
4. Remove the sealing cover.
5. Remove the rear sash.
6. Remove the three screws.
7. Disconnect the connectors, and then remove the front door latch and door lock actuator assembly.






INSTALLATION
Install in the reverse order of removal.

Tightening torque:
T1: 6.5 (0.66, 4.8)
T2: 7.5 (0.76, 5.5)
T3: 18 (1.8, 13.3)

NOTE: Make sure the lock works correctly after installation.