Rear Seat
REAR SEATDISASSEMBLY
1. Remove the rear seat.
2. Remove the armrest hinge cover in the direction of black arrow, and loosen the screws to remove the armrest.
NOTE: The armrests cannot be detached while the backrest assembly RH and armrest side pin positions are not aligned.
3. Remove the backrest knob. (Screw-in type) (Wagon model)
4. Remove the seat back latch cover.
5. Turn over the backrest cover to remove the hog rings.
6. Remove all the hog rings securing the backrest frame and backrest pad.
7. Remove the headrest bushing.
8. Remove the backrest pad and backrest cover from the backrest frame.
9. Disassemble the backrest assembly LH by referring to above procedures.
10. Remove all the hog rings on the rear side of the seat cushion to separate the seat cushion cover and cushion pad.
11. Open the plastic fastener, then remove the headrest cover from the headrest.
12. Remove the plastic fastener and hog rings, and then remove the armrest cover.
ASSEMBLY
Assemble in the reverse order of disassembly.
CAUTION:
- Always use new hog rings.
- Secure the hog ring using hog ring pliers.
- Install the hog rings to the specified points securely and make sure that no wrinkle or twisting on backrest cover.
NOTE:
- Do not contaminate or damage the cover.
- While installing the hog rings, prevent the seat from getting wrinkled.