Condenser HVAC: Service and Repair

Condenser

REMOVAL
1. Using the refrigerant recovery system, discharge refrigerant.
2. Disconnect the battery ground cable from the battery.
3. Disconnect the pressure hose and pipe from the condenser.






4. Remove the radiator brackets.






5. Remove the front bumper.
6. Remove two bolts. While lifting the condenser, pull out through space between the radiator and the radiator panel.






CAUTION:
- Be careful not to damage the condenser fins. If a damaged fin is found, repair it using a thin screwdriver.
- If the condenser is replaced, add an appropriate amount of compressor oil to the compressor.

INSTALLATION
1. Install in the reverse order of removal.

CAUTION: Replace the O-rings on hoses or pipes with new parts, and then apply compressor oil. Confirm that lower guide (A) of condenser fits into holes on radiator panel.






2. Charge refrigerant.

Tightening torque:

Air Conditioning Unit
T1: 7.5 (0.76, 5.5)
T2: 10 (1.0, 7.4)
T3: 5 (0.5, 3.7)


Refer to RADIATOR & RADIATOR FAN, COMPONENT, General Description.