Operation CHARM: Car repair manuals for everyone.

Oil Filter: Service and Repair

Engine Oil Filter

REMOVAL

CAUTION:
If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.


1) Set the vehicle on a lift.
2) Lift up the vehicle.
3) Remove the oil filter using the ST.
ST 18332AA000 OIL FILTER WRENCH (Outer diameter: 68 mm (2.68 in) for oil filter)
ST 18332AA010 OIL FILTER WRENCH (Outer diameter: 65 mm (2.56 in) for oil filter)





INSTALLATION

CAUTION:
Do not tighten excessively, or oil may leak.


1) Clean the oil filter installing surface of cylinder block.
2) Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.
3) Install the oil filter turning it by hand, being careful not to damage the seal rubber.
^ Tighten the oil filter 65 mm (2.56 in) in diameter (approx. 2/3 - 3/4 rotation) after the seal rubber of the oil filter comes in contact with cylinder block or oil cooler. When using a torque wrench, tighten to 12 N-m (1.2 kgf-m, 8.7 ft-lb).
^ Tighten the oil filter 68 mm (2.68 in) in diameter (approx. 1 rotation) after the seal rubber of the oil filter comes in contact with cylinder block or oil cooler. When using a torque wrench, tighten to 14 N-m (1.4 kgf-m, 10.3 ft-lb).

4) Lower the vehicle.

INSPECTION
1) After installing the oil filter, run the engine and make sure that no oil is leaking around seal rubber.

NOTE:
The filter element and filter case are permanently jointed; therefore, interior cleaning is not necessary.

2) Check the engine oil level.