Front Hub Unit Bearing
Front Hub Unit BearingDISASSEMBLY
Using the ST and a hydraulic press, push out the hub bolts.
ST 28399AG000 HUB STAND
CAUTION:
^ Be careful not to hammer the hub bolts. This may deform the hub.
^ Do not reuse the hub bolt.
NOTE:
Since the hub unit bearing can not be disassembled, only hub bolts can be removed.
ASSEMBLY
1) Attach the hub to the ST securely.
ST 927080000 HUB STAND
2) Using a press, press the new hub bolts until their seating surfaces contact the hub.
NOTE:
Use the 12 mm (0.47 in) dia. holes in the HUB STAND to prevent bolts from tilting.
INSPECTION
Refer to "Front Axle" for inspection procedures.
CAUTION:
If there is any fault in the bearing, replace hub unit bearing.