Select Cable

ADJUSTMENT
1) Set the vehicle on a lift.
2) Lift up the vehicle.
3) Shift the select lever to "N" range.
4) Remove the rear exhaust pipe and muffler.
^ Non-turbo model

^ Turbo model

5) Remove the heat shield cover.





6) Loosen the adjusting nuts on both sides.





7) Turn adjusting nut B until it lightly touches the connector.





8) Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.





9) After the completion of adjustment, confirm that the select lever operates normally at all ranges.
10) Install in the reverse order of removal.